CDA EIN Series Manuel d'utilisateur

1Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HYT : 01949 862 012 F : 01949 862 0

10

11

12Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HYT : 01949 862 012 F : 01949 862

2ImportantThe manufacturer cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note that

3Using your ExtractorFor best performance, you should switch on the extractor 15 minutes before starting to cook and leave it to run for approximately

4Care and MaintenanceIMPORTANT : DO NOT PERFORM MAINTENANCE OR CLEANING OF THE EXTRACTOR WITHOUT FIRSTSWITCHING OFF THE ELECTRICITY SUPPLY.CleaningYou

5Changing the LightDO NOT CHANGE THE LIGHT BULB IMMEDIATELY AFTER USE AS THE BULB WILL BE HOT. ALLOW IT TO COOL BEFORE REMOVING IT.Remove the cover pa

6DOUBLE POLE SWITCHED FUSED SPUR OUTLETUSE A 3 AMP FUSEMains Electricity ConnectionTHIS APPLIANCE MUST BE CONNECTED TO THE MAINS SUPPLY BY A COMPETENT

7Electrical InformationMains electrical voltage: 230 – 240Vac.Total rated power consumption: 160W.TroubleshootingIf your extractor is not working:1.

8InstallationWhen the extractor is to be installed above an electric hob, the minimum distance between the hob and extractor must exceed 600mm (650mm

95555323.5Adjacent CabinetInstallation1. Mark the positions of the fixing holes on the wall using the dimensions shown above.2. Drill and plug the wa