Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HYT : 01949 862 012 F : 01949 862 003 E : se
10Care And MaintenanceCleaning The FilterThe filter is found, by opening the door (fig.2.) and must always be in position when drying items in the appl
11Troubleshooting If the clothes are not dry after normal drying time:- Check that the filter is clean.- Check that you used the correct heat setting.-
12Installation/ventingThis appliance is fully compatible with any 600mm deep kitchen units and complies with stringent EEC regulations.Your dryer is s
13 PLEASE NOTE: The air vent at the front of the appliance must never be covered or blocked in any way as this will impair the functioning of the appl
14Reversing The DoorThe door on the dryer can be positioned either with the left or right hand hinging, as shown in fig.6. Please note: power tools mu
15Electrical informationWarning! This appliance must be earthed.The mains lead of this appliance has been fitted with a BS 1363A 13 amp fused plug. To
16As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug
17
2ImportantThis appliance must only be used for the purpose for which it is intended, i.e. domestic use. Any other use could be dangerous and may lead
Please contact our Customer Care Department, or for Service on the details below.Customer Care Department • The Group Ltd. • Harby Road • Lang
3CE Declarations of Conformity:This appliance has been designed, constructed and marketed in compliance with safety requirements of EEC Directive 2006
4User Information The room must be adequately ventilated to avoid the backflow of gases into the room from appliances burning gas or any other fuels.
5Do not Dry wool or wool mixture articles unless the article is labeled as suitable. This should avoid shrinkage.Do not Items such as foam rubber
6Use And Controls 1. Programme selector: Choose the final dryness of the load by selecting the desired dryness setting (see the programme chart).
7Programme ChartProgrammes 1-7 can be operated on either full heat or half heat setting and include a 12 minute cool-down period at the end of the cyc
8To run a programme• Sort out the clothes into groups of similar fabrics and colours. Check the care label inside the garment. We suggest that a fab
9Use And Controls Should the clothes dry before the cycle has finished the thermostat will automatically switch o the heater to prevent over drying an
Commentaires sur ces manuels