CDA FW223 Manuel

Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HYT : 01949 862 012 F : 01949 862 003 E : cu

10TroubleshootingIf you have any problems with your appliance, you should check the troubleshooting prior to calling CDA Customer Care to prevent unne

11There is water in the lower part of the refrigerator compartment• The drain hole in the channel at the back of the compartment is clear.Installati

12Fig. 4 - Dimensions of the applianceFig. 5 - Fitting the worktop bracketRemove the screw (5) on the top of the appliance, locate the top bracket(6)

13Fig. 7 - Adjusting the appliance heightThe height of the appliance can be adjusted by the help of adjustable feet to fit the furniture height. Use a

14Fig. 10 - Fitting the decor door bracketUnscrew and remove the nuts and washers from the appliance door. Place fixing bracket on the appliance door

15Fig. 12 - Fitting the decor doorPlace the decor door onto the appliance door by inserting adjustment bolts into the slots on the fixing bracket. Loc

16Fig. 15 - Fitting the decorative coverFit the decorative cover (4) on the decor door fixing bracket.Fig. 16 - Fitting the plinthFit the plinth sectio

17Reversing the DoorIt is possible to reverse the door on this appliance, if required. To do so, follow the steps below:1. Open the door.2. Loosen

18Electrical InformationWarning! This appliance must be earthed.The mains lead of this appliance has been fitted with a BS 1363A 13 amp fused plug. To

19As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug

2ImportantThe CDA Group Ltd cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note tha

Please contact our Customer Care Department for Service on the details belowCustomer Care Department • The Group Ltd. • Harby Road • Langar •

3CE Declarations of Conformity:This appliance has been designed, constructed and marketed in compliance with safety requirements of EEC Directive 2006

4ImportantNever store inflammable or explosive items and strong corrosive acids or alkalis in the appliance.This is a household appliance, which is pro

5Before First UseYou must allow the fridge to settle for at least twenty four hours prior to switching the power on.It is recommended that you clean t

6Setting the TemperatureYou must allow the fridge to settle for at least twenty four hours prior to switching the power on.To adjust the temperature t

7UseFridge• Never put liquids in the refrigerator uncovered.• Never put hot foods in the refrigerator. Warm food should be allowed to cool to room t

8Care and CleaningAlways disconnect the appliance from the power supply before any cleaning or maintenance.The fridge sections should be cleaned using

9Defrosting the FridgeThe fridge is self-defrosting. Any water created will run out of the fridge through the channel at the back of the fridge.It is