CDA HVG620 Manuel d'utilisateur

Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HYT : 01949 862 012 F : 01949 862 003 E : se

10Mains Electricity ConnectionTHIS APPLIANCE MUST BE CONNECTED TO THE MAINS SUPPLY BY A COMPETENT PERSON, USING FIXED WIRING VIA ADOUBLE POLE SWITCHED

11Assembly and electrical connection should be carried out by specialised personnel.When installing this product we recommend you seek the help of ano

12recovery scavenging system• The connection to the gas supply must comply with all current regulations in force.• We are not legally able to oer

13Natural Gas to LPG ConversionThis hob can be converted from natural gas to propane operation at anominal inlet pressure of 37mbar, or butane operati

144. Turn the controls to maximum position then quickly to the minimum position - make sure the flame does not extinguish.5. Replace the knobs.LPG t

15Fitting the HobUnpacking the hob:Take care not to lose or mishandle any parts.Fitting position of the hob:This appliance must be installed a minimum

16Notes:• Do not position this appliance above a refrigeration unit. The heat generated may cause the refrigeration unit to fail.• This appliance

17How to Install the HobHow to install the hob:Overall hob dimensions: HVG620 = 580mm (W) x 500mm (D) HVG720 = 700mm (W) x 510mm (D) Worktop cut

18

19

2ImportantThe manufacturer cannot be held responsible for injuries or losses caused by incorrect use or installation of this product.Please note that

Please contact our Customer Care Department, or for Service on the details below.Customer Care Department • The Group Ltd. • Harby Road • Lang

3safety (LVD) and Electromagnetic interference compatibility (EMC). Parts intended to come into contact with food conform to EEC/89/109.IMPORTANT INFO

4• This hob (Class 3) has been designed for use only as a cooking appliance. Any other use (e.g. heating rooms) should be considered incorrect and p

5Gas burners:Gas flow to the burners is controlled by the control knobs (5, 6, 7 and 8 or 14, 15, 16, 17 and 18 on the diagram above). There are 3 posi

6Igniting the BurnersThe hob is fitted with a flame failure device. Flame failure devices operate by shutting o the supply of gas to the burner in the

7• If a burner does not ignite, or turns o accidentally, turn the control knob to the ‘o’ position, and wait for one minute before attempting to

8Care and MaintenenceAs the hob has a glass surface, you should use a nonabrasive cleaner. Any abrasive cleaner (including Cif) will scratch the surfa

9Burner Size Nominal Rating(kW)Simmer Rating(kW)LPG Flow Rate (lh-1)G30 G31Auxiliary 1.0 0.6 72.8 71.5Semi-Rapid 1.75 0.8 134.6 132.2Rapid 3.0 1.2 218