CDA HG7300 Manuel de service télécharger pdf (Page 11)

Fig. 8

Fig. 7

Burners and Grids

– These parts can be removed and cleaned with appropriate products.

– After cleaning, the burners and their flame spreaders must be well dried and correctly replaced.

– It is very important to check that the burner flame spreader and the cap have been correctly positioned. Failure

to do so can cause serious problems.

– Check that the electrode “S” (figs. 7 - 9) is always clean to ensure trouble-free sparking.

– Check that the sensor “T” (figs. 7 - 9) next to each burner is always clean to ensure correct operation of the safety

valves.

– Both the probe and ignition plug must be very carefully cleaned.

– Note: To avoid damage to the electric ignition do not use it when the burners are not in place.

Correct Positioning of the Burners (Auxiliary, Semi-rapid and Rapid burners)

– It is very important to check that the burner flame spreader “F” and the cap “C” have been correctly positioned

(see figs. 7 and 8). Failure to do so can cause serious problems.

Ignitor “S”

Sensor “T”

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Pas de commentaire

CDA HG7300 Manuel de service Page 11