CDA hn6110 Spécifications télécharger pdf (Page 19)

IMPORTANT - PLEASE NOTE: In the event of any breakage, crack

or cracking – even minimal – of the vitroceramic glass, immediately

disconnect your appliance to prevent a risk of electric shock and

contact CDA Customer Care.

IMPORTANT:

When correctly installed, your product meets all safety

requirements laid down for this type of product. However, special

care should be taken around the rear or the underneath of the

appliance as these areas are not designed or intended to be

touched and may contain sharp or rough edges that could cause

injury.

Fitting the Hob

Unpacking the hob:

Take care not to lose or mishandle any parts.

Fitting position of the hob:

This appliance must be installed a minimum of 50mm from any

back wall and a minimum of 180mm away from any adjacent vertical

surfaces, e.g. a tall cupboard end panel. This may be reduced to

100mm if the adjacent surface is resistant to ﬁre (tiles or steel, for

example). These dimensions are shown in Fig. 5.

Ventilation requirements:

This appliance must be installed to allow air to ow freely to the air

intake, from the air outlet and in the base and run of units into which

it is installed (Fig 3). Failure to allow sucient ventilation could cause

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

Pas de commentaire

CDA hn6110 Spécifications Page 19