10 11
You observe that Possible Causes What should you do?
The display shows a series of digits and
symbols on first connection
Working normally
Nothing, the hob will be ready to use
within approximately 30 seconds
Installation blows a fuse or
only one side of the hob works
The electrical connection of the hob
is incorrect
Check that it is set up properly (see the
Electrical Connection section)
The hob produces an odour during the
first cooking sessions
New appliance
Heat a saucepan full of water on each
cooking zone for 30 minutes
9 fast frying steaks
Troubleshooting
On first use
Should any error code other than those listed above show on the zone displays, contact CDA Customer Care for
assistance
iMPORTANT - PLEASE NOTE: In the event of any breakage, crack or cracking – even minimal – of the vitroceramic glass,
immediately disconnect your appliance to prevent a risk of electric shock and contact CDA Customer Care.
You observe that Possible Causes What should you do?
The hob has stopped operating. The
hob beeps and ER03 is displayed on
the zone display
There was an overflow or an object is in
contact with the control panel
Clean the hob or remove the object,
and begin cooking again
The hob has stopped operating and
the display shows E2, ER21 or ER40
The electronics have overheated
Allow the hob to cool down.
See the Installation section to check the
ventilation requirements have been met
After turning on a zone, the zone
display shows
The cookware used is not suitable for
induction or is less than 11cm on the 160mm
zones, or 145mm on the 200mm zones
See the section on cookware for
induction
The saucepans make noise
during cooking or your hob makes a
clicking sound during cooking
This is normal with some types of cookware.
This is caused by the transfer of energy from
the hob to the cookware
Nothing. There is no risk, neither to
your hob nor to your cookware
The fan continues to function for a few
minutes after the hob is turned off
Cooling of the electronic components.
Working normally
Nothing.
You observe that Possible Causes What should you do?
The hob does not work and the lights on
the control panel do not switch on
The hob is not connected to the power
supply or the power supply is faulty
Check the electrical circuit breaker and
fuses
The hob is not working and the display
shows a non-standard graphic
The electronics are not functioning
correctly
Call CDA Customer Care
The hob is not working and the display
shows
The safety key lock is on Switch off the safety key lock (see page 7)
fast frying steaks
On switching on
Troubleshooting
In use
(16 pages)
(32 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels