CDA HVN91 Manuel d'utilisateur télécharger pdf (Page 21)

• If an oven is to be installed below the hob, the thermal safety

system on the hob will not allow the hob to be used at the same

time as a pyrolytic programme on the oven.

• The hob is equipped with an anti-overheating safety device that

can be activated if the hob is installed over an oven that is not

suciently ventilated. In the event that this occurs, the zone display

will show C. We recommend that you increase the ventilation of the

hob by creating an opening in the side of the cabinet (8 cm x 5 cm).

How to install the hob:

Overall dimensions of the hob:

HVN61FR: Width: 580 mm

Depth: 510 mm

HVN81FR: Width: 770 mm

Depth: 510 mm

Worktop cut-out dimensions:

HVN61FR: Width: 560 mm

Depth: 490 mm

HVN81FR: Width: 750 mm

Depth: 490 mm

1. Make the required hole in the work-

top. Before doing this, you must

check the instructions supplied with

any cooker hood to ensure that you

will have the required clearance. The

cut-out (Fig.6) shows a 60mm gap

Fig.4

Ho b

Top rail removed to allow air to exit.

Recommended 560mm x 6mm

Air intake into the run of units.

Recommended 560mm x 10mm

A ventilation slot may need to be cut

into the base if there is no ventilation

provided.

Recommended 560mm x 25mm

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28

Pas de commentaire

CDA HVN91 Manuel d'utilisateur Page 21