CDA CST Manuel d'utilisateur

Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HYT : 01949 862 012 F : 01949 862 00

Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HYT : 01949 862 012 F : 01949 862 00

ImportantThe CDA Group Ltd cannot be held responsible for injuries or losses caused by incorrect use or installation of this product

Using your ExtractorFor best performance, you should switch on the extractor 15 minutes before starting to cook and leave it to run for appro

Care and MaintenanceIMPORTANT : DO NOT PERFORM MAINTENANCE OR CLEANING OF THE EXTRACTOR WITHOUT FIRST SWITCHING OFF THE ELECTRICITY SUPPLY.Cleaning Yo

Changing the LightDO NOT CHANGE THE LIGHT BULB IMMEDIATELY AFTER USE AS THE BULB WILL BE HOT. ALLOW IT TO COOL BEFORE REMOVING IT.Open the base o

DOUBLE POLE SWITCHED FUSED SPUR OUTLETUSE A 3 AMP FUSEMains Electricity ConnectionTHIS APPLIANCE MUST BE CONNECTED TO THE MAINS SUPPLY BY A COMPETENT

Electrical InformationMains electrical voltage: 230 – 240Vac.Total rated power consumption: 165W.TroubleshootingPlease note:• Your extractor is eq

InstallationWhen the extractor is to be installed above an electric hob, the minimum distance between the hob and extractor must exceed 600mm (650mm i

Mounting your ExtractorThe extractor can be mounted in one of two ways:To fasten the product to the underside of a bridging cabinet:To fasten the prod