CDA HCG 730 Users operating instructions Manuel du propriétaire télécharger pdf (Page 87)

Figure 34. Removing and installing a processor

1. close first socket-release lever 2. pin-1 indicator of processor

3. processor 4. slot (4)

5. processor shield 6. open first socket-release lever

7. socket 8. socket keys (4)

d. Hold the tab on the processor shield and lift the processor shield until the open first socket-

release lever lifts up.

CAUTION: The socket pins are fragile and can be permanently damaged. Be careful not to

bend the pins in the socket when removing the processor out of the socket.

e. Lift the processor out of the socket and leave the open first socket-release lever up.

NOTE: If you are permanently removing the processor, you must install a socket protective

cap in the vacant socket to protect the socket pins and keep the socket free of dust.

NOTE: After removing the processor, place it in an anti-static container for reuse, return, or

temporary storage. Do not touch the bottom of the processor. Touch only the side edges of

the processor.

Next steps

1. Replace the heat sink(s) and processor(s). See Installing a processor.

2. Follow the procedure listed in After working inside your system.

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 207 208

Pas de commentaire

CDA HCG 730 Users operating instructions Manuel du propriétaire Page 87