CDA 4X9SS Manuel télécharger pdf (Page 10)

- Connecting gas

- Ensure that it has been adjusted to local fuel types.

- If it has not been adjusted, follow adjustment instructions as set out in

‘Adjustments for alternative gas types’.

If it is to be fuelled by liquid gas, only a certified and approved pressure

regulator is to be used.

- Connect the appliance to gas cylinder or other gas supply in accordance

with local codes and regulations.

- Connecting appliance

- The hob can be installed with either an approved stainless steel flexible

pipe or a rigid pipe.

Connection is made to the GJ1/2” threaded elbow.

- The gasket has to guarantee the connection holds fast.

- The elbow can be turned by releasing the nut. Once the desired position

has been established it is to be tightened again.

Fig. 3

Important: After the installation check there are no leaks by using a soap

solution and never a flame.

The manufactured declines every responsibility if these safety

standards are not respected.

Fitting for metal pipe

Gasket

Nut

Shaft

pipe

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Pas de commentaire

CDA 4X9SS Manuel Page 10