CDA 4X9SS Manuel télécharger pdf (Page 13)

- Repairs on electrical parts

Before calling the Technical Assistance Service check that:

The plug has not come out of the socket.

The main switch in the home is on.

If necessary, have the appliance serviced by qualified personnel.

Remove the plug from socket before disassembling any part.

- Replacement of feed cable

The feed cable must be in HO5 RR-F, with a cross sectional area of 3x1 mm².

It can be replaced as follows:

- open the terminal board;

connect the wires to their terminals: N – L – Earth;

secure the wire with the cable clamp;

- close the terminal board with screws;

Fig. 5

N.B.:

After installation the lead must be accessible.

- Adapting hob burners to other types of gases

These hob models are fitted with burners that require no air regulation. For this

reason, to adapt the appliance to work with a gas different to what it has been set

for, simply substitute the nozzles and adjust the minimum.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Pas de commentaire

CDA 4X9SS Manuel Page 13