
INSTRUCTIONS FOR THE INSTALLER
Installation must be performed by a qualified installer and conform to local codes,
and carried out with extreme care.
Prior to installation, ensure that the local distribution conditions (nature of gas and
gas pressure) and the adjustments of the appliance are compatible.
The gas adjustment conditions for this appliance are stated on the data plate
located on the back of the appliance (see fig. 2)
Fig. 2
Installation and adjustment must be done with maximum attention by qualified
personnel and in accordance with current standards.
If the appliance has to be adapted to a gas type different from the original
one, enclosed with the guarantee you will find two labels for the installer to
affix on the appliance’s rating plate and on the guarantee to make the new
adjustment known.
- Electrical connection
Before connecting to the electricity mains first check that:
- the electrical supply system is fitted with an effective earth connection; to
the contrary it must be done separately and in compliance with current
EEC standards;
- The socket or four-pole connecting switch are easy to reach once the
appliance is installed.
The hob is supplied with lead on which a standardised plug must be fitted that will
withstand the load indicated on the appliance’s rating plate; the plug must then be
plugged into a suitable socket (Fig. 2). In all cases you must take the precaution
to position the lead so that it will never exceed a temperature that is 50°C higher
than environmental temperature in any one point.
The manufacturer declines all responsibility if these accident prevention
rules and regulations are not abided by.
0051
F.lli BARAZZA
Questo apparecchio deve essere installato conformemente alle norme
in vigore e utilizzato solamente in un locale ben areato. Consultare
il libretto
istruzioni prima di installare e usare l'appar ecchio.
Commentaires sur ces manuels