CDA 4X9SS Manuel télécharger pdf (Page 15)

b) Regulating the minimum

To adjust the hob burner minimum, light the burners and turn them down to

minimum (serigraphed small flame). Take the knob off (it simply pulls off) and

insert the screwdriver (provided with the appliance) in the screw in the knob

holder pin (Fig.7): turn this screw to the right to make the flame smaller or to the

left to make it bigger until you reach the minimum wanted.

If the appliance is working on liquid gas (G30/G31), the minimum adjustment

screw must be screwed down completely. After these conversions and

adjustments use soapy water to check for gas leaks and make sure the burners

and working properly. Turn quickly the knob from maximum to minimum, the

flame mustn’t extinguish, in case it comes, adjust the minimum again.

Fig. 7

Attention:

Check the condition of the flexible gas pipe periodically and change it whenever

you notice it is deteriorating. It is advisable to check it at least once a year. It

must only be changed by qualified personnel.

WARNINGS:

- If the burner flame goes out accidentally, close the knob and do not attempt to

light it again for at least 1 minute.

- When gas cooking appliances are used they produce heat and humidity in the

room in which they are installed. Please ensure good aeration in the room

keeping the natural ventilation vents free and open or install a suction hood with

discharge duct.

- An intensive and prolonged use of the appliance might need additional aeration

like, for instance, the opening of a window or a more effective aeration, increasing

mechanical suction power if it exists.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Pas de commentaire

CDA 4X9SS Manuel Page 15